ZBrush 3D Printing workflow tutorial

Published: 14 January 2014
on channel: Konrad Dobson

12,025

114

Tutorial starts at 01:24.

A quick little ZBrush tutorial explaining the workflow I picked up to succesfuly 3D print a model and save money on wasted material. I hope you find it helpful!

NOTE: I probably should have explained from the start that the goal of this was to create a hollow mesh ready for 3D printing, and with a hole in the top to allow the filament powder to escape the mesh. If you don't do that, you will have to pay for the filament which can be rather expensive. Basically the filament powder is used where there is no 3D printed plastic laid down. The plastic forms the borders, and the filament becomes the inside filling and is removed and blown out later. It helps reinforce the structure while it's solidifying. Hope it helps!

On this page of the site you can watch the video online ZBrush 3D Printing workflow tutorial with a duration of hours minute second in good quality, which was uploaded by the user Konrad Dobson 14 January 2014, share the link with friends and acquaintances, this video has already been watched 12,025 times on youtube and it was liked by 114 viewers. Enjoy your viewing!