FlatCam gerber to gcode for laser plotting
The output from flatcam has gcode commands for cnc milling. We will show you how to change these for laser plotting.
G0 is rapid movement. CNC z height will be above workpiece AND for laser beam is off
G1 is slow movemnt. CNC z height is in workpiece AND for laser beam is on
//begin
M3 S0 = laser on constant power, power 0%
F4000 = movement feedrate mm/min
// change command to lower cnc (ex: G01 Z-0.0020) mill into
S200 = power 20%
//change command to raise cnc mill (ex: G00 Z0.1000) into
S0 = power 0%
//at the end
S0 = power 0%
M5 = laser off
On this page of the site you can watch the video online FlatCam gerber to gcode for laser plotting with a duration of hours minute second in good quality, which was uploaded by the user Wim Provoost 02 July 2023, share the link with friends and acquaintances, this video has already been watched 5,045 times on youtube and it was liked by 35 viewers. Enjoy your viewing!
