G-Code Basics
Hi!
In this video, I'll teach you the basics of G-Codes in the field of 3D-printing with some very easy and understandable examples.
Thru this video I hope to motivate more people to do some easy G-Codes by themselves because it's not complicated at all.
G-Code for determining the build-plate center: https://pastebin.com/Q9VKPe3M
FYI: I set my build-plate volume to 200x200mm in Cura.
RepRap Wiki about G-Code: http://reprap.org/wiki/G-code
Expect an upgrade video next week.
A detailed list of all active upgrades can be found below, as well as a link to my 3D-printing playlist.
If you have any questions, or feedback on how I can improve, feel free to leave it in the comments section below!
Enjoy the video!
-----------------------------------------------------------------------------------------------------------
This video is part of my 3D-printing playlist: • 3D-Printing
About my Technologies:
3D-Printer: Anet A8 (original)
Ordered from: https://www.3dprintersbay.com/
Upgrades:
Semi-Circular Fan Duct: http://www.thingiverse.com/thing:1954001
Y-Belt Tensioner: http://www.thingiverse.com/thing:1959208
X-Belt Holder: http://www.thingiverse.com/thing:1666094
T-Bracket (frame stabilization): http://www.thingiverse.com/thing:1672959
E3D-v6 carriage: http://www.thingiverse.com/thing:2099577
Bowden motor bracket: http://www.thingiverse.com/thing:2146021
Camera + Microphone: Oneplus One, OBS studio, the t.bone SC450
Editing Software: kdenlive for Windows
On this page of the site you can watch the video online G-Code Basics with a duration of hours minute second in good quality, which was uploaded by the user Caverntwo 26 March 2017, share the link with friends and acquaintances, this video has already been watched 5,628 times on youtube and it was liked by 57 viewers. Enjoy your viewing!
