Plate Forging Process Simulation |

Published: 25 June 2020
on channel: AFDEX

1,326

In this video, you will learn how to simulate a single-stage cold plate forging process using isothermal analysis module of AFDEX 3D, the intelligent metal forming simulation software.

Since the geometries of the workpiece and the dies are symmetric, we will carry out a 3D simulation of a 30 degree sector of the component.

The material of the workpiece is a steel grade named AISI 1010 and its initial temperature is that of room temperature.

The temperature change will not be considered in this simulation. A blank holder force of 5 kilo Newton is applied in this process.

A glimpse of the post-processing options available in AFDEX will also be shown at the end of the video.

Enjoy the learning process. And to learn more about AFDEX and metal forming simulation technology in general, visit our homepage
https://afdex.com/

Music: https://www.bensound.com

On this page of the site you can watch the video online Plate Forging Process Simulation | with a duration of hours minute second in good quality, which was uploaded by the user AFDEX 25 June 2020, share the link with friends and acquaintances, this video has already been watched 1,326 times on youtube and it was liked by 6 viewers. Enjoy your viewing!

388